Guidelines for Fiber Optic Cable Installer

Fiber Optic Cable Installer : 

• Never directly pull on the fiber itself. Fiber optic cables have Kevlar aramid yarn or a fiberglass rod as their strength member. you ought to pull on the fiber cable strength members only!
• Never exceed the utmost pulling load rating. On long runs, use proper lubricants and confirm they're compatible with the cable jacket. On really long runs, pull from the center bent both ends. If possible, use an automatic puller with tension control or a minimum of a breakaway pulling eye. Know and observe the utmost recommended load rating of the cable.
• Never exceed the cable bend radius. Fiber is stronger than steel once you pull it straight, but it breaks easily when bent too tightly. These will harm the fibers, maybe immediately, maybe not for a couple of years, but you'll harm them and therefore the cable must be removed and thrown away!
• Always roll the cable off the spool rather than spinning it off the spool end. this may put a twist within the cable for each activate the spool! Never twist the fiber cable. Putting a twist within the cable can stress the fibers too.
• Make sure your fiber cable is long enough for the run. Fiber splicing make things complicated and expensive. And it needs special protection. attempt to make it in one pull.
• Indoor cables are often installed directly, but you would possibly consider putting them inside innerduct. Innerduct provides an honest thanks to identify fiber optic cable and protect it from damage, generally a results of someone cutting it by mistake! you'll get the innerduct with pulling tape already installed.
• Plan the Installation. Create an in depth , written plan of installation. you'll eliminate 95% of the issues installers can encounter by simply creating this plan. The plan should include equipment and supplies, fiber cable specification, location of kit , testing requirements, data forms for testing, personnel experience level and assignment, installation methods, identification of potential problem areas, questions of safety , etc.
• Pull, don't push cables. Pushing may result in violation of the bend radius.
• Monitor the availability reel. Monitoring the availability reel during installation is important to stop violation of minimum bend radius.
• Communicate along the trail of installation. When installing long runs, communicate and monitor along the trail of the installation. Fiber cables can and do jump from unmonitored pulleys. The minimum crew should have one person monitoring the pulling equipment, one monitoring the availability reel, and one coordinating all involved within the installation.